[Qlustar-General] Re: Failed to run qluman-cli -bootstrap during second phase installation

Hi Roland, Unfortunately I already removed this installation, so I lost the file. Anyway, I think the problem was due to the hardware not allowing for virtualization. I disabled the FrontEnd VM and the TestVM options in the first stage and now the installation procedure was able to move forward. I will install the front-end on a different machine later on. Best regards, Cesar

On Tue, Jan 8, 2019 at 3:48 PM Roland Fehrenbacher rf@q-leap.de wrote:

...

...

...

...

...

"C" == clavila clavila@gmail.com writes:

Hi Clavila,

could you please send the contents of the file

/etc/qlustar/qluman/installsettings

Best,

Roland

C> Dear all, I am trying to install the latest version of Qlustar
C> (10.1) in a server. During the first phase everything runs
C> smoothly. During this stage I opted to run the front end on a
C> VM. I have also setup manual network configurations for both
C> cl-head and cl-fe.  When I start the second phase after reboot by
C> running qlustar-initial-config I get an error during qluman
C> setup.

C> To try to isolate the error, i ran the qlustar-initial-config -i
C> -d (interactive and debug flags enabled). The output that I get
C> is attached below. Any ideas on how to fix this?  Cheers, Cesar

C> run "qluman-cli --bootstrap" [n] Yes

C> -- Starting Qluman bootstrap ...........

---

Qlustar-General mailing list -- qlustar-general@qlustar.org To unsubscribe send an email to qlustar-general-leave@qlustar.org