Having a few issues during the initial install of Qlustar.
- Started with a clean install of Qlustar. - All was going well and then the error "failed to start rng-tools.service." - The installed continued on its own to the "Welcome to Qlustar 10..... " screen. - At the root@cl-head~# prompt I entered /usr/sbin/qlustar-inital-config command. - Next error message encountered was during the gluman bootstrap - couldn't determine IP address.... Install continued to the configure slurmbd section - Entered my slurm password twice and and I receive this error after several minutes of waiting - "sacctmgr: Can't connect do slurmbd - exiting"
Any thoughts?
"B" == Bob Johnson xyzemail19@gmail.com writes:
Hi Bob,
B> Having a few issues during the initial install of Qlustar. B> * Started with a clean install of Qlustar. B> * All was going well and then the error "failed to start B> rng-tools.service."
that's not critical at this stage of the install.
B> * The installed continued on its own to the "Welcome to Qlustar B> 10..... " screen. B> * At the root@cl-head~# prompt I entered B> /usr/sbin/qlustar-inital-config command. B> * Next error message encountered was during the gluman B> bootstrap - couldn't determine IP address.... Install B> continued to the configure slurmbd section
Most likely you have chosen DHCP as the method to configure the external network interface of your head-node during install. It looks though as if the head-node wasn't able to receive an IP address from your DHCP server after the initial boot. Presumably you cannot ssh into your head-node either, correct? Please make sure, that the external interface of your head-node is configured. Check that your external DHCP server is working or use the manual method to give the head-node a static IP.
B> * Entered my slurm password twice and and I receive this error B> after several minutes of waiting - "sacctmgr: Can't connect B> do slurmbd - exiting"
That would be a consequence of the unconfigured network adapter.
Cheers,
Roland