"J" == jorma ojala <jorma.ojala@iki.fi> writes:
Hi Jorma, J> Hi, Qlustar 10.1 installation failed on HP DL320 G6 server. The J> server has got 4 x 1TB disks, but the installer reported 'no J> unused disks'. I recall that the server has got the P410 J> RAID-controller on-board. I tried with different RAID J> configurations but with no luck. Maybe this is 'too old' J> hardware for Qlustar ? Cheers, Jorma that's weird. The P410 should be supported by the hpsa kernel module which is part of the Qlustar kernel. You can try to get a shell during an installer run by pressing 'Ctrl-t c' after the welcome screen has appeared. On the prompt (#) that should then appear, type bash to get a sane shell environment. From there, you can check whether hpsa is loaded: $ lsmod | grep hpsa If it's not, try to load it manually $ modprobe hpsa and check whether the kernel reports any detection: $ dmesg | tail -20 Also check what block devices have been setup: $ lsblk Hope this will shed some light ... Cheers, Roland